1. Change Mode 1 to Mode 2 for the transmitter of the Zhenhua transmitter:

2. Open the back cover:

3. Inside configuration:

4. Take off the right screw with a plastic part 1:

5.  And a spring (note nether another plastic part 2 for the spring):

6. Take off the plastic part 2 from ather side:

7. That is the plastic part 2:

8. look at 3 parts took off:

9. Take off the left screw:

10. With the spring piece:

11. Move it to right side:

12. Install it here:

13. That is right:

14. Install the plastic part 2 to left side:

15. Put in here:

16. Here is right:

17. Put the spring into here:

18.  And link the plastic part 2 together:

19. Link the plastic part 1 to end of the spring:

20. Put the plastic part 1 to own place:

21. Yes,that is OK:

22. Then,open the electronic board:

23. Take off 2nd and 3rd BNC connector plugs

24. ...

25. Exchange them each other and put in the BNC:

26. Put the electronic board to the place before:

27. Put the switch plastic part to here:

28. Install the back cover:

29. All right,that is the Mode 2: