1. Change Mode 1 (right hand throttle) to Mode 2 (left hand throttle) for the Optic6 transmitter:

2. Take off the TX  module:

3. Take off the antenna.

4. Open the back cover of the transmitter by 6 screws:

5. Take off left covers and right:

6. Open the back cover:

7. Inside configuration:

8. Take off the screw:

9. Take off the spring reed:

10. Take off the screw:

11. Install the spring reed to another side:

12. Fix the screw here:

13. Take off the screw:

14. Take off the plastic part:

15. Install the plastic part to another side same place:

16. Fix the plastic part by the screw:

17. Finish the job:

18. Close the back cover:

19. Install 6 screws:

20. Take off the plastic part 2 from ather side:

21. That is the plastic part 2:

22. look at 3 parts took off:

23. But no finish the Mode 2,needs setup internal program by the screen of the transmitter:

24. First press down 2 kays 'EDIT' same time,then switch on the power of the transmitter:

25. Press down the 'EDIT' right key:

26.Press down the 'CURSOR' right key,change the MODE 1 to MODE 2:

27.Switch off the transmitter:

THE END