SPECIFICATIONS

 1. Input power: 4.5-6V                              2.  Input signal: 1.0-2.0ms

 3. Weight: 6.5g                                          4. Size: 30X18X8.3mm

 USER GUIDE::

 1. The  G104 gyro is designed for 6CH and up R/C system only. sensitivity of the gyro can be

 make via the transmitter Rudder ATV and/or through  the switches on the gyro unit.

 2.  Connect the gyro to the rudder channel of the receiver and the gain control. Wire should be 

 connnected to  AUX  channel (Signal) of The receiver .Connect the rudder servo to gyro,  Turn

on the power of the transmitter then the receiver. Place the AUX switch on the transmitter in the

down position (ratehold ,the  LED  on the gyro is turn Green). 

 3.  Make sure the servo arm at the center position Adjust the length of the rudder control rod to

 meet the full traveling range of the rudder of the rudder. In initial flying, the adjustment should be

 done under rate holding mode. When the initial setting is completed and Check the correct rudder

 movement during low altitude.  

  4.  If the rudder control drift one way, put your Helicopter down on the ground and adjust the

 length of the rudder control rod. After finishing the adjustment ,turn the gyro to head holding mode

(place  AUX  switch on the transmitter in the up position) ,the sensitivity of the gyro should be

 between 70%-80%.  

  ATTENTION:

  When assemble the gyro to your plane ,Make sure the up direction is the same as show as diagram

.The DS switch must put to “ON” position when using digital servo.